BNR32 running 2 different TSC's simultaneously ?

[Allan74]

Well, not really simultaneously.......but both installed and only 1 activated at a time.

Does anyone see any problems with running a setup like this ?

I have an Extreme TSC (front TQ enhancing in the corners) with the 2WD/4WD toggle switch that I wanna use for Burnouts and Road Course and I also want to wire in a Grid TS Dancer for Drag Racing (front Diff TQ limiting/Preload).

Has anyone done anything similar to this ?

Bad Idea ? or all will be OK with just making sure only 1 is powered at a time..... ?

Comments ?

[sidewayz32]

I don't see how that could pose a problem, just wire a switch into the hot wire for each so it could be disconnected maybe im wrong though?

[mcfly]

Im not electrical engineer but just thinking about how this would be done in my head is one messy drawing because ideally you cant have any wires cut and going through the other module. more then likely you would need to tap the same system twice and that gives me a headache.

[Allan74]

Now that my TS-Dancer has arrived, I'm gonna have to lay it all out in front of me, along with the Extreme TSC..... and see what the possibilities are.

I am thinking that a basic multiple contact 3 possition switch (on-1/off/on-2) might be do able, otherwise, I may have to get fancy with some relays.