Attesa Transfer Case Rebuild

[rb-racer]

I am curious what parts I would need in the event I wanted to rebuild my transfer case.

it would be a bnr32 one if that makes a difference.

[mcfly]

When I get back to my desktop I will look up some parts.
What is leading you to a rebuild in the first place? I ask because these cases are very robust.

[rb-racer]

Well i am concerned the transfer case is just tired. I felt i wasn't getting much power out of the front.

[Skym]

Torque split setting??

I think JUN, Kakimoto sell upgraded transfer case internals.

[mcfly]

Its a big request so i will try and finish it tonight.

there really is no need to upgrade the internals though skym. There has only been one instance of a chain breaking apparently.

[Bignate]

Its a big request so i will try and finish it tonight.

there really is no need to upgrade the internals though skym. There has only been one instance of a chain breaking apparently.

yeah lots of 1000hp GTR's running the stock transfer case if im not mistaken. Chances are there is a torque split controller though too.

[rb-racer]

I'm not concerned about the power holding capacity.
I have time to wait for the part numbers and is it possible to get screen shot or the parts your pulling off.

[mcfly]

Well here you go. These parts are what you need to replace for a slipping box rebuild. There are also 3 oil seals which would be useful to replace just in case.

Look closely at the quantities

[rb-racer]

thanks, thats not as bad a list as i was expecting

[GTR--J]

Does anyone know a rough estimate for a rebuild with the above parts?
Parts= $?
hours=?